Use of Byproduct Lime on Agricultural Soils

Products such as water treatment and sugarbeet lime can pose opportunities and challenges for growers.

Published online: Sep 11, 2017 Bob Battel, Michigan State University Extension

As harvest progresses throughout the state, farmers can take advantage of the open ground to apply lime to acidic soils. Liming acidic soils to a near neutral pH (6.5 to 6.8) is one of the most important practices in managing soil fertility, according to Michigan State University Extension. Properly limed soils have improved nutrient availability, microbial activity and overall soil productivity.

Traditionally, growers use ground calcitic limestone (CaCO3) or dolomitic limestone (MgCO3●CaCO3) to reduce soil acidity. Some growers may have the opportunity to use byproducts of municipal water softening, or sugarbeet processing to lime their soils. Growers can use these materials effectively to raise soil pH. These materials are often available to growers for less expense than agricultural lime. Often, the growers pays a small fee, plus trucking, or perhaps pays only trucking charges for the byproduct lime. However, users should be aware of the properties of these materials and be prepared to handle them differently than ground agricultural lime.

Municipal water treatment can include the use of hydrated lime to remove dissolved calcium and magnesium ions from the water, thus softening it. Farmers can use the resulting byproduct as a liming agent. The acid-neutralizing value of the water treatment lime can be similar to, or even greater than, ground ag lime. The material is also very fine, dissolving and reacting quickly in the soil solution.

By the nature of its production, water treatment lime is very wet—40 to 50 percent moisture. Because of its wet, fine particles, water treatment lime can be difficult to spread in a uniform fashion, resulting in bands of heavy lime alternating with bands of light lime applied throughout the field. These bands can ultimately result in areas of very high soil pH. Care should be taken to ensure an even spread. A special spreader designed to handle wet materials may be needed. Because the product dissolves so quickly, users may consider using less of the product than a soil test recommends and apply the product more frequently. Agricultural lime contains a range of particle sizes to raise and maintain the soil pH over a three- to five-year period. Water treatment lime will raise the pH quickly, but will not maintain it.

Lime is also used in processing sugarbeets to remove impurities from the sugar. The resulting byproduct is a liming material that generally has a lower acid-neutralizing value than agricultural limes. Therefore, the beet lime should be spread at a greater per-acre rate than traditional ground agricultural lime. Beet lime contains fine particles and therefore reacts quickly in the soil, but may not maintain the soil pH as long as ag lime. Beet lime can also have a lot of moisture; similar to water treatment lime, care should be taken to ensure an even spread.

Knowing the neutralizing value (NV) of a lime source is useful in calculating spreading rates for lime sources. Pure, finely ground CaCO3 has an NV of 100. Typical agricultural limes, with minor impurities and an array of particle sizes, has an NV of 90. Soil test recommendations for spreading lime are based on a material with an NV of 90. Water treatment and sugarbeet limes have neutralizing values of up to 120 and 80 to 90, respectively. Hence, it takes less water treatment lime, and often more sugarbeet lime, to neutralize acid soils.

Users should have a laboratory analysis performed on any liming material before it is applied to their fields. The analysis typically includes NV, particle size distribution, percent moisture/dry matter and percent magnesium.


Source: Michigan State University Extension